The following instructions and diagrams are a guide to help you install the brackets to your vehicle.

1. Set out all components and familiarise yourself with contents.

2. Measure length and height of lightbar to determine approximate plank and position the light will be mounted (forward mount or under mount) (Forward mount bracket)

2a. If using forward mount plates, assemble included M8x18mm button head bolt through side plate into main bracket and affix flat washer and nylock nut on back and tighten to sufficient torque.

4 PLANK RHINO RACK

5 PLANK RHINO RACK

3. Assemble one M8x20mm, spring and flat washer through slotted hole in top plate and rubber dampener and loosely attach rectangle channel nut (a couple of threads will be sufficient). Offer assembled bracket to appropriate plank, lining up channel nut, and slide forward and finger tighten. Alternatively, position channel nut into the ‘C’ channel of the platform and place bracket over this and affix with the M8 button head, spring and flat washer.

4. With the help of a friend, offer light bar to bracket and use the hardware supplied with the light bar to fasten into Roof rack bracket.

5. Carefully align the two brackets and light bar to sit symmetrical on the roof rack and tighten.

6. Once light bar is wired up, head out to you favourite dark location and aim the light bar and torque down tightly. (Refer to Roof Light Bar wiring instructions for methods of installation)

Good to know: Our main mounting arms of our Rhino bracket has intentionally been designed to be 1mm undersized. A small amount of pressure will need to applied to push the bracket down on the upper plank to then secure the channel nut. This pre-loads the bracket with tension which in turn eliminates any prospect for vibration on installed.

1. Insert channel nut & loosely fit the light bar to the bracket arm.

2. Apply pressure to the bracket arm pushing down on the top plate.

3. Insert bolt into channel nut whilst still applying pressure to bracket arm.

Note: In order to mount a Curved series ST2K bar, you will only be able to mount it underneath the rack. A minimum height of 90mm will be required to do this. There are two ways to mount this bracket to suit the curved light. See below.